10 Easy Steps!!
1. We seal off every register to increase the negative pressure created by our vacuum.
2. We open up the access hole to the main trunks of the duct work in the basement.
3. The vacuum gets hooked up to the duct system and is fired up.
4. We then go to every registered and blast 190psi air through the ducts to knock all the dirt down into the main trunk.
5. Once all the dirt is contained in the main trunks, we begin with a whip to loosen all the dirt in the main trunks. The whip or 'octopus' acts like a scrub brush to loosen the dirt off all four sides of the trunk.
6.After the dirt is loose, we use a spinner ball with 190 psi to blow all the dirt and direct it to our vacuum hose which sucks it out of your home never to rest on your china cabinet again!
7. All access holes are sealed up and made air tight again.
8. All registers are unsealed again.
9. We clean up in and around your furnace.
10. We show you the finished results and make sure you are happy!!!